Gf-signet 9900-1BC Batch Controller System Bedienungsanleitung PDF herunterladen (Seite 6)

6 9900-1BC Batch Controller Manual

System Start-up: Step 2

Wire the transmitter connections with the power off. Keep any 4 to 20

mA and relay-actuated output devices that are connected to it ofﬂ ine at

this time. Wire the sensor (pg. 7), power (pg. 8) and Open Collector and

relay(s) (pg. 9).

Next step: System Setup (Step 3).

Wiring Tips:

• Do not route the sensor or DC power cables in conduit containing AC power

wiring. Electrical noise may interfere with sensor signal.

• Routing the sensor cable in grounded metal conduit can help prevent

electrical noise and mechanical damage.

• Seal the cable entry points to prevent moisture damage.

• Only one wire should be inserted into a terminal.

• Splice double wires outside the terminal or use appropriate wire ferrule,

not to exceed 2 mm (0.08 in) diameter.

Tools Required

• Phillips screwdriver

• Flat-head screwdriver

• Wire strippers

Wiring

All wiring connections to the 9900-1BC are made via removable terminal plugs.

In general:

• Terminals accept 12 to 24 AWG wire.

• Strip 7 mm (0.28 in.) of insulation from wire tips and tin bare ends to

eliminate fraying.

• Insert wire tip or ferrule completely into the terminal and secure with

the screw.

• Do not allow any AC leads that may be connected to the internal relays to

come in contact with low voltage wiring.

CAUTION:

DO NOT bundle Relay Module

wiring with other wiring.

Doing so may cause injury and/or damage to

9900 Transmitter, Relay Module, and Batch Module.

• Minimize handling of plug-in modules to reduce the possibility of

damage due to ESD.

• Handle modules by the edges. Never touch any exposed circuitry or

contacts.

• Wear an anti-static wristband or stand on an anti-static mat, or

keep one hand touching a properly grounded pipe or other properly

grounded piece of metal when handling modules.

CAUTION:

Avoid Electrostatic Discharge (ESD)

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Gf-signet 9900-1BC Batch Controller System Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Werkzeug Gf-signet 9900-1BC Batch Controller System